ju52junk Posted April 9, 2018 Report Posted April 9, 2018 (edited) Hasegawa Hurricane. Eduard PE cockpit. CMK resin wheels, Montex canopy mask, Resin tail wheel/strut, Quickboost Resin Exhausts, Resin prop and spinner, Vallejo paints, AK panel line wash, AML camouflage mask. Had trouble with this build(all self induced). The right side landing light when clipping off the sprue was ejected into the ever hungry "carpet monster" never to be seen again. Also, as you can see in the photo the fin flashes did not react well (wrinkled) to Walther's solvaset. Must of broke the tail wheel, rear antenna mast and lower pitot tube about a half dozen times. Edited April 10, 2018 by ju52junk
ghodges Posted April 10, 2018 Report Posted April 10, 2018 Looks the part, despite the problems you mentioned. You did a very good job of the getting the roundels and side codes to take to all of those ribs. You might try putting a small piece of old pantyhose over the end of your vacuum hose and then see if you can suck that light back out of the carpet. It should end up stuck on the outside of the pantyhose! GIL
Recommended Posts