carmelin1

Check on ARC this was posted there yesterday. Carl I have a review of the new 1/48 resin S35E Draken Recce conversion by Maestro Models Conversions from Rebell Hobby. This new resin nose permits you to converts the 35E Draken into a Recce nose S35E Draken and is designed for the new 1/48 Hasegawa J35 Draken.

Can you point me to the Scaleliners website? I mixed my own SW Gold. I used an Insignia Red. David go to the Hannents web site http://www.hannants.co.uk/ and do a search 1/144, Boeing 737, Decals, or just 1/144, 737 and they will come up. They show them as low stock so hurry. Hannents is the only place I have been able to find them. They also have the Daco kits abd some Jet decals. It's painfull that the rate is $1.86 to the Pound Sterling.

Thanks David, I ordered 2 sets trom Scaleliners one each -300,-500 Classic color scheme and the same Canyon Blue scheme. I also ordered Jet 737-300 AZ state flag scheme. I ordered some Boeing Gray, Canyon Blue and SW Gold from Xtra color. Any referencies or suggestions for the rest of the colors I think there Orange and Red would be appreciated.

Thanks everyone. I am planning to do a few Southwest Airlines Aircraft in the different paint Schemes in 1/144 scale. I ordered the Daco Skyline 737-500 and 2 737 300.s I also want to do a 737-700 but wasn't able to find a kit in 1/144. I have the Revell 737-800 and it looks longer then any pictures I have seen of Southwest Acft. Thanks David that is exactly the info I was looking for. I think the -800 will become a -700. Looks like I will be busy on the internet looking through all those sites. Thanks again everyone. Carl

Hi all, any Airliner modelers out there. I need some information on the Boeing 737's. Any one know of a good reference book or web site that describes the differencies between the -300,-500 and -700 models. In the photos I have found they don't look any longer as is obvious in the -800. Are they different inside maybe glass cockpit, seating arrangement. Or do they have upgraded engines. Need to know if a -700 can be made from a -500 or -300 model. Any help would be appreciated. Carl

Don't Laugh but WD-40 works well on old masking tape. Just apply it with a cotton bud. Try it on area that is not too visible before you commit your self to the whole model. Clean the WD-40 off with soap and water. Not sure if if works on clear. I never tried i on that.t.Carl