Search the Community
Showing results for tags 'classic kit'.
Last year iModeler member Tom Bebout sent me some classic kits with the request I would build them. I told him I would and here is the first one of them. It is an older Airfix kit with the original first issued in 1963 as kit 386. As I began to build it I soon began to like this pudgy little fat fellow. First thing I did was sand down the rivets and second thing was to figure out how to improve the clear parts. Common with Airfix kits with cabin window is that there is always a nice big sink mark in the middle of the clear piece. For the nose windows I used Microset Clear window glue which worked OK. On the side fuselage windows I sanded and polished out the parts hoping to remove the sink mark. It worked on some and others it didn't. To seal the side windows I experimented with two kinds of clear glue on the inside to prevent them from popping off. Unfortunately the interaction between the clear gorilla glue and the other clear glue caused some white specks on the windows. Lesson learned. Practice on a test kit before using it on a build. I masked the fuselage windows with a mask ordered off eBay. The canopy frames are thin strips of decal painted with the correct color. The paints are from Tamiya (sky), AK (Dark Earth) and Mission Models (green). I used blue tac to mask the camo pattern and it worked well. The decals were slightly out of register so I replace the roundels, codes and fin flash markings with decals from my spares binder. I flattened the finish with Dullcote. The motto on the side of fuselage is supposed to be on each side. I screwed up the starboard side ones so only the port side has them. The nose cap, lower clear part and turret are glued in place with clear Elmer's glue. Somewhere on the floor or on my bench is a small landing gear door that popped off, but is not noticeable. The next one will be the Monogram 1/48 TBF.