Jump to content

Eduard Dh2 Rigging Info Needed


rhester

Recommended Posts

Bob,

 

Eduard site has instruction sheets for their "real" DH-2 kits ...

Try these 3 links from the Profi-Pack kit:

http://www.eduard.cz/products/pdf/n80/8094_10.pdf

http://www.eduard.cz/products/pdf/n80/8094_11.pdf

http://www.eduard.cz/products/pdf/n80/8094_12.pdf

 

HTH

Link to comment
Share on other sites

Guest Bun E. Carlos

And Bob........a suggestion..............Use Stretched Sprue!!!!!!! You'll need a ruler/Dividers.....#11 Blade........Elmers Glue & tweezers!

Link to comment
Share on other sites

Boy I'll tell you what, I wouldn't use stretched sprue for the DH2. While you go in to heat shrink one wire you'll be damaging the others already in place. I'd bite the bullet, get a pair of dividers and put each wire on one at a time in the exact length it needs to be. Work from the inside out. If you can, rig the booms before you install them (the cross bracing I mean) making that an integral part of the sub assembly. I'm not one to use drilled holes to rig. I use CA+accelerator or Testor's Clear Parts Cement to install rigging on my WWI a/c.

Link to comment
Share on other sites

Not to mention my OPTIVISORs...

 

Hey, at least it'll be easier to rig than my 1/72 scale DH 2 was! Mine wasn't rigged accurately, but I got it rigged using 'invisible' nylon thread that was smaller than 2lb. test line. Feel free to check it out on my Thread posted below.

Link to comment
Share on other sites

×
×
  • Create New...