Ron Bell Posted March 17, 2022 Report Share Posted March 17, 2022 AZ makes kits of subjects others don't and that's the only reason I build them 'cause they are only about 1-2 steps above limited run injection kit quality. They usually include some PE and their decals are good, but the plastic is rather soft, fit is 'iffy' and there is much clean up involved. However, if you stick with it, you can get decent/good results. This is OOTB but I left off the tiny screens that fit in front of those intakes aside the radiator as I just couldn't get them to go on correctly. Link to comment Share on other sites More sharing options...
Mark Deliduka Posted March 17, 2022 Report Share Posted March 17, 2022 Another brilliant model from you Ron! Fantastic! Link to comment Share on other sites More sharing options...
Stikpusher Posted March 18, 2022 Report Share Posted March 18, 2022 Wow! That is BRIGHT!!! 😎 That is a sharp looking build of a lesser seen type. Bravo! 👍🏼👍🏼 Link to comment Share on other sites More sharing options...
ghodges Posted March 27, 2022 Report Share Posted March 27, 2022 Great looking build of a rare subject! I'm betting it took more elbow grease than you alluded to to get such a crisp result. Gil Link to comment Share on other sites More sharing options...
MDriskill Posted May 23, 2022 Report Share Posted May 23, 2022 Very nice! Good scheme on an unusual type. You may be surprised to learn that the Fulmar actually achieved 122 air-to-air kills, more than any other FAA fighter type. AZ often uses molds originally designed by other companies; I believe their Fulmar is the one originally released under the "Vista" brand. Link to comment Share on other sites More sharing options...
Roktman Posted June 8, 2022 Report Share Posted June 8, 2022 Nice job! I too like to build the oddball type planes. This one is very cool! Link to comment Share on other sites More sharing options...
Recommended Posts