cheveuxroux Posted February 20, 2022 Report Share Posted February 20, 2022 I have a large and thin model car kit plastic part that has been broken into three pieces. While I may eventually permanently glue it together for use with the original kit, I would prefer to temporarily glue the parts together with the clear canopy so that I can duplicate the exterior multi-curved surface. The measurements would be used for the creation of a either a male or female vacuum form mold ; used to create one clear part as a replacement for the two original kit parts. Question; Is it possible to temporarily glue the three opaque pieces and clear together without harming the plastic ? Anyone able to recommend a glue for the task? Link to comment Share on other sites More sharing options...
Eric Posted February 21, 2022 Report Share Posted February 21, 2022 If you can support the pieces to allow for drying time either white glue or testor's clear parts cement should work. Eric 1 Link to comment Share on other sites More sharing options...
cheveuxroux Posted February 21, 2022 Author Report Share Posted February 21, 2022 Testors Clear parts cement? Thank you ! I intend to make a support for the parts. I only need to keep the three pieces in place while I do measurements. Link to comment Share on other sites More sharing options...
Recommended Posts