Jump to content

Modelsvit XP-55 Ascender


nmertes

Recommended Posts

Have any of ya'll built the Modelsvit XP-55 Ascender & used the Scale Aircraft Conversions landing gear & nose wheel well kit?  The nose wheel well in the SAC set I received is about 1/8th short.  I contacted SAC.  They're sending me a mailing label & will recast a new wheel well for me.  They indicated it looked like Modelsvit replaced the kit wheel well with a resin part.  The gray piece in the photo was cut off sprue E.  No resin in the kit.

 

I've been emailing Ross at SAC about the problem with the nose wheel well part.  It appears they made their molds from the original version of the kit.  Modelsvit re-did the sprue with the wheel well to correct the length.  

PXL_20211009_233219561.jpg

Edited by nmertes
Link to comment
Share on other sites

×
×
  • Create New...