Jump to content

Constitution deck

Recommended Posts

  • 3 weeks later...

If you glue them I don’t think you will be able to spread the Hull to get them in place.

I did not glue mine till after they were in place and it worked ou quite well.

Check out your instructions I don’t believe they say to glue the decks together prior to installation.

I am about 1/2 done and find the kit to be a real challenge as there is a lot of parts pep sanding and trimming.

Other wise it is fun to see it coming together



Link to post
Share on other sites
  • 2 weeks later...

Absolutely glue them together first.  You will notice that the deck surface does not line up perfectly.  By gluing them together ahead of time, you can add some reinforcements under the deck using stock styrene.  This will really firm up the deck and allows you to get everything even.  And yes, you can still spread the hull apart enough to get it in.  I did a complete wooden deck on a single sheet of styrene which was popped in and out several times to check for fit and lighting placement (yes, I lit the gun deck with LEDs).  To slide the glued up deck in, start by putting the bow section in about 4 to 5 inches back - about where the opening in the gunwales starts.  As you spread the deck apart aft, just continue to slide the deck forward until it meets the bow.  In reality, getting the gun deck in is MUCH harder than the spar deck.  All of my hints and complete build (thus far) are on the FineScale Modeler site under "Luvspinball."


Link to post
Share on other sites
  • Create New...