Jump to content
Sign in to follow this  
IPMSUpdates

New Review: Standard Nose F-5 Pitot

Recommended Posts

Product Image

The Master products are very fine and well done brass parts to update or repair your kit. In this case, it was an F-5A which I built several years ago, and the pitot tube was badly bent. Also, the guns were barely visible.

This set consists of a brass pitot, two 20mm guns, and a fairing which can replace the left gun.

The upgrade is pretty simple. You get a .3mm drill. Remove the kit pitot and drill a hole there. The guns require a little more work, as there isn't a good place to start drilling. I began by using a #1 blade to dig the guns out, then drilled the .3 mm holes. Then I installed the pitot and the guns. I had to use a little filler under the guns to get them looking good.

I painted the area with the same gray I used to paint the model, then highlighted the guns. I used Testors "Burnt Metal" for these, as I find gun metal to be too dark.

And the project was done. Looks good.

read more

View the full article

Share this post


Link to post
Share on other sites
Sign in to follow this  

×
×
  • Create New...