Jump to content
Sign in to follow this  

New Review: 25-degree Sprue Cutter

Recommended Posts

Product Image

If you build models you are probably very familiar with Micro-Mark.  Not only do they carry a wide range of modeling tools but also offer several kits in different media.

When starting a model getting the parts off the sprue cleanly helps lower the amount of clean up you need to do so finding a good sprue cutter is a great start.  This product is manufactured by Fujiya out of Japan.

I tried it out on a kit I am working on for a review and it did a great job.  The 25-degree angle gives good control to get up next to the part no matter the placement on the sprue.  The cut was clean, but you need to make sure you are even with the part edge or you will live a bit of the connection.

read more

View the full article

Share this post

Link to post
Share on other sites
Sign in to follow this