Jump to content

Is This The Correct Quick Rlease Connectors 4 My IWATA M2 A/Brush ?


schooner

Recommended Posts

Hi Guys ( Newbie Here Still )

 

I have YET to set-up my airbrush due to the fact I'm trying to buy the necessary equipment I need to get started such as: Hose & Quick Release Connectors.

 

The problem is right now (I need your help)

Is this the correct connectors I need for me yet to buy air hose.

 

http://www.tcpglobal.com/ABDTF-117.htm

 

As always I await your decision on if this is the correct connectors I need.

post-3123-0-43701500-1482683668_thumb.jpg

Link to comment
Share on other sites

You simply have to get the size of the male connector on the airbrush to match the female connector on the hose from the compressor. They may already match. Otherwise, adapters can be bought with appropriate sized connectors. Your compressor or airbrush dealer probably sell them. Just figure the size you need for each end to step up or down the size. And they do not need to be quick release.Simple threaded connectors work fine and are probably cheaper.

Link to comment
Share on other sites

×
×
  • Create New...