Kranman Posted February 24, 2009 Report Share Posted February 24, 2009 I grabbed a tube of this to try and have mixed results. It sands well but is definately not my Nitro Stan glazing putty. It's got a different consistency and seems to take a long time to cure and I was wondering what you guys might use it for, if you use it at all... Frank Link to comment Share on other sites More sharing options...
Dick Montgomery Posted March 2, 2009 Report Share Posted March 2, 2009 I use an auto-body putty called, "3M Acryl Blue". It's $25 a tube but my first tube lasted for 10 years! It is a fine grain putty and feathers extremely well with sandpaper. One can sand dry or wet, either way it works well. It dries quickly, depending on how thick one applies it. Wetting it with finger nail polish remover allows an even smoother surface than just the putty applied with the fnpr., but that slows drying time. I swear by this stuff and use either it or stretched sprue without exception. Link to comment Share on other sites More sharing options...
Guest Bun E. Carlos Posted March 2, 2009 Report Share Posted March 2, 2009 Hey Dick............where did you get it??? Link to comment Share on other sites More sharing options...
TimHortman Posted March 3, 2009 Report Share Posted March 3, 2009 I had to special order mine from the local NAPA, but it wasn't difficult to get. I can post all of the stock #'s in info in anyone needs them... I've had my tube for years, and there is still way over 80% left... Link to comment Share on other sites More sharing options...
Guest Bun E. Carlos Posted March 4, 2009 Report Share Posted March 4, 2009 thanks timmy..................i'll look on my way home Link to comment Share on other sites More sharing options...
TimHortman Posted March 5, 2009 Report Share Posted March 5, 2009 Here's the info in case anyone needs it. My tube is well over 5 years old, so there is a chance that it has changed somewhat since then: 3M Acryl-Blue Glazing Putty 1lb 5oz tube Part # 051144 - 05964 Link to comment Share on other sites More sharing options...
GLW Posted March 10, 2009 Report Share Posted March 10, 2009 Anybody use Bondo? I got half a tube from a guy that was moving and it seems ok. Hate to pitch it if it's usefull. G.L. Link to comment Share on other sites More sharing options...
JayMesawitz Posted March 10, 2009 Report Share Posted March 10, 2009 I have a tube of 'Bondo' glazing putty that works just fine (only because when I went looking for the 3M stuff the guys at Napa looked at me like I was some kind of nut). I used it in a heavier fashion on a project that is now about two years old... no sign of shrinkage and that is key to whether what you have is any good. I still use my Bondo brand but have also added a two part catalyzed filler to the arsenal. All to avoid shrinkage. Oh what would Freud think? Link to comment Share on other sites More sharing options...
GLW Posted March 11, 2009 Report Share Posted March 11, 2009 Freud? Didn't he have his brainstorm about shrinkage right after a cold shower? So whats the best thinner/remover for bondo? G.L. Link to comment Share on other sites More sharing options...
Recommended Posts