DaveD

Bryan, thanks for the feedback. I currently have an ANycubic Photon, a Resin LCD printer that was substantially 1/10 of a Form2 with 25-100 micron layer resolution, i't a little small of a print area, but will be a less of a challenge over time. So far the biggest challenge is completely cleaning the resin off the print and fully curing the print after clean. I personally want more control of those processes to get a more consistent product. It's going to be an interesting journey. //dd//

I am doing research into 3D printing a 1/35th Scale water trailer, this is initial investigation and just looking for interest in whether I should even attempt it if there is no interest. Initially learning how to design using a parametric modeling program and then get the 3D printer. This subject is usually towed behind a 2.5 Ton 6x6 or the newer FMTVs. This usually is included in the logpacks going to infantry and armor companies(chow and water are almost inseparable and would be a good addition for dioramas or loads for trucks Not sure if I would have Shapeways handle fulfillment or whether I would just produce in the basement. Looking to retire into this in two years to keep me sane. Would like to know if this would be of interest to the Armor community Thanks, David Dodge