Leaderboard

The build continues on the OV-1C Mohawk. The first thing I did was to detail the nose gear bay with more photo etch so I could install the cockpit/nose gear assembly into the fuselage. Once done, I was able to assemble the fuselage together. The instructions call out to add 19 grams of weight to the nose so the model will sit on the gear rather than its tail. I actually added about 22 grams. Only 15 grams fit in the nose so I added the rest on the sides of the nose gear bay between the bay and fuselage wall. I then began work on the wings. The first step was to cut out the entire main gear bays as these were completely replaced with photo etch parts. The bays were then primed with white primer. The main struts were then detailed with photo etch details. The engine exhaust area was detailed with photo etch and the kit exhaust was replaced with the upgraded resin version. The resin version is a seamless casting and shaped a little better than the kit version. The exhaust was painted then weathered with pastel chalk. The wing halves were then put together and finally the main gear was installed onto the wings. Next up is the tails and fuselage detailing. You can see all the photos and details from the start in my build log at https://davidsscalemodels.com/build-log/1-48-ov-1c-mohawk/